Which gateway is used by vSAN kernel by default?

vSAN unlike vMotion does not have dedicated TCP/IP stack. This means it uses default gateway.

In clusters where vSAN uses a single L2 domain it is not a problem. In cases where there are multiple L2 domains within a cluster (stretched cluster, dedicated L2 domain per site, clusters that span racks in a Leaf and Spine topology) we need to define static routes to reach other L2 domains.

It is important to know that when you enter a dedicated gateway address for the vSAN network (Override default gateway for this adapter) it does not override the routing table on the ESXi host:

ESXi attempts to route all traffic through the default gateway of the default TCP/IP stack (Management) instead.

So far, the only option to route traffic via dedicated gateway for vSAN is to create a static route using this command:

esxcli network ip route ipv4 add --gateway IPv4_address_of_router --network IPv4_address 

Other useful commands:

esxcli network ip route ipv4 list

esxcli network ip route ipv4 remove -n network_ip/mask -g gateway_ip
esxcfg-route -l

Let’s not forget about the most important one after every change in the network: vmkping:

If you have Jumbo Frames configured in your environment, run vmkping with -d (disable fragmentation) and -s (size).

Leave a Reply

Your email address will not be published. Required fields are marked *